Hot & Cold Water Pipes in Glasgow
New runs, replacements and leak repairs. Isolation valves, stopcocks, manifolds and neat routing & lagging.
Low pressure, leaks or planning a refurb? We install and replace hot and cold water pipework for kitchens, bathrooms and loft conversions, fix bursts, re-route untidy runs and upgrade stopcocks/PRVs and isolation valves — leaving everything pressure-tested and tidy.
When to renew or re-route pipework
Persistent leaks, green/white crust on joints
Poor flow/pressure at taps or shower
Refurbishing kitchens/bathrooms or moving appliances
Old or mixed pipework causing noise or temperature swings
Exposed, untidy or badly clipped runs
What we do
New hot/cold pipe runs (copper or WRAS-compliant PEX)
Leak tracing & repairs (compression, soldered, push-fit as appropriate)
Stopcock replacement/relocation and PRV installs
Isolation valves at each outlet; manifold setups
Re-routes for neat, accessible pipework; removal of dead legs
Lagging/insulation to prevent heat loss & condensation
Outside taps with double check valves (on request)
Our process
Survey & options (AM/PM) — Photos/measurements, pressure/flow checks, routing plan.
Fixed quote — Clear scope and materials.
Installation/repair — Isolate, protect, fit/reroute, clip and lag.
Testing — Pressure/flow test and leak checks.
Handover — Show stopcock/isolation points and aftercare.
What’s included
Qualified plumber; Gas Safe engineer available if gas work is involved
WRAS-compliant fittings & materials
Protective coverings and clean workspace
Pressure/flow test results
Clear pricing before work begins
Note: Chasing/boxing and final decoration by others if required — we’ll advise before starting.
Typical time to completion
Stopcock/valve swap: 30–60 mins
Small re-run/repair: 1–3 hours
Full kitchen/bath re-pipe: half–full day (scope dependent)
Clear pricing & booking
We give a fixed, written quote after survey — no surprises.
Call 0141 374 0545 or Request a Visit to choose an AM/PM slot.
Urgent water leak?
Turn off your main stopcock (usually under the kitchen sink or where the pipe enters the property). If stuck or you can’t find it, call us and we’ll guide you.
BeSafe 24-7 is a Glasgow-based team of Gas Safe Registered engineers helping homeowners with boiler repairs, servicing/CP12, new installs, plumbing, gas and drainage. We prioritise safety, tidy work and clear pricing—so you always know where you stand.
About
BeSafe 24-7 provides boiler repair, servicing/CP12, installs and plumbing across Greater Glasgow. Gas Safe Registered (930395).
Note
If you smell gas or suspect CO, call 0800 111 999